Some photos of a little hacking on Nvidia Jetson TK1…
Plutarco’s Nvidia Jetson TK1 is a good mainboard but power supply connector isn’t suitable for a outdoor robot in a heavy vibration environment… and a little hacking can be suggested 🙂
-
- Start soldering 2 wire to connector pads on bottom side of board
-
- With coated paper make an edge around soldered pad
-
- You need to create a box to keep glue on correct position and form
-
- Fill box with hot glue…
-
- …and await complete cooling down.
-
- Remove paper edged with a cutter
-
- Improve glue-box dimension and aspect
-
- and this is finished work
